Akai MPC User's Guide download pdf (Page 143)

143

Control Change (Controllers): MIDI messages enable you to manipulate the behavior of a sound

generator to a significant degree. This message essentially consists of two components:

• The controller number, which defines the parameter to be influenced. It can range from 0 to 127.

• The controller value, which determines the extent of the modification.

Controllers can be used for effects such as slowly swelling vibrato, changing the stereo panning position

and influencing filter frequency.

Cutoff: The cutoff frequency is a significant factor for filters. A low-pass filter for example dampens the

portion of the signal that lies above this frequency. Frequencies below this value are allowed to pass

through without being processed.

Decay: Decay describes the descent rate of an envelope once the Attack phase has reached its

maximum and the envelope drops to the level defined by the Sustain value.

Envelope: An envelope is used to modulate a sound-shaping component within a given time. For

instance, an envelope that modulates the cutoff frequency of a filter opens and closes this filter over a

period of time. An envelope is started via a trigger, usually a MIDI Note. The classic ADSR envelope

consists of four individually variable phases: Attack, Decay, Sustain, and Release. Attack, Decay and

Release are time or slope values, while Sustain is an adjustable level. Once an incoming trigger is

received, the envelope runs through the Attack and Decay phases until it reaches the programmed

Sustain level. This level remains constant until the trigger is terminated. The envelope then initiates the

Release phase until it reaches the minimum value.

Filter: A filter is a component that allows some of a signal's frequencies to pass through it and dampens

other frequencies. The most important aspect of a filter is the filter cutoff frequency. Filters generally come

in four categories: low-pass, high-pass, band-pass, and band-stop. A low-pass filter dampens all

frequencies above the cutoff frequency. A high-pass filter in turn dampens the frequencies below the

cutoff. The band-pass filter allows only those frequencies around the cutoff frequency to pass; all others

are dampened. A band-stop filter does just the opposite; it dampens only the frequencies around the

cutoff frequency. The most common type is the low-pass filter.

LFO: LFO is an acronym for low-frequency oscillator. The LFO generates a periodic oscillation at a low

frequency and features variable waveshapes. Similar to an envelope, an LFO can be used to modulate a

sound-shaping component.

1 2 ... 138 139 140 141 142 143 144 145 146 147 148

No comments

Akai MPC User's Guide Page 143