Akai DPS12 Operator's Manual download pdf (Page 86)

Chapter 7: Advanced technique for mixing

4. Press the [F3] key in Assign mode and assign and to Tracks 1 and 2

respectively.

Input signals from the OPTICAL IN jacks will be assigned to physical tracks 1 and 2.

5. Set Tracks 1 and 2 to record waiting mode, and start recording.

Using the Solo function

The mixer section of the DPS12 provides a Solo function that allows specified channels to be routed to Master L/

R. This function is useful when you wish to monitor only certain input signals or tracks. The Solo function is

available whenever the transport operations on the DPS12 are available (that is, in Main mode, Track View mode,

Mixer mode, and when the Control Panel is displayed).

1. Press the [SOLO] key to use the Solo function.

The [SOLO] key LED flashes and the Solo function is enabled.

➸

NOTE :

If you press the

[SOLO]

key in Main mode, Track View mode, or when the Control Panel is

displayed, the function indication for the

[F1]

and

[F2]

keys will change from and to

and , as seen in Mixer mode. This means that you can use the

[F1]

and

[F2]

keys to toggle

between TRACK MIX channels and THRU MIX channels. A symbol appears along with the function

indication for the currently-selected channels.

• When TRACK MIX channels are selected

• When THRU MIX channels are selected

2. Press the [F1] key to solo a TRACK MIX channel, or press the [F2] key to solo a THRU

MIX channel.

3. Use the [RECORD SELECT] keys to select an individual channel to monitor.

Use a corresponding [RECORD SELECT] key to select a channel. Each [RECORD SELECT] key corresponds

to a channel, as follows:

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 155 156

No comments

Akai DPS12 Operator's Manual Page 86