Akai DPS12 Operator's Manual Page 74

  • Download
  • Add to my manuals
  • Print
  • Page
    / 156
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 73
62
Chapter 6: Mixer Function
Equalizer settings
You can set the parameters for the 3-band (HIGH – shelving type, MID – peaking type, and LOW – shelving type)
equalizer.
NOTE :
You can use the 3-band equalizer for up to six channels. If you wish to apply equalization to all
twelve channels, switch to the 2-band (HIGH, LOW) equalizer. With a sampling rate of 48kHz, 3-band
equalization can be applied to up to five channels, and 2-band equalization to up to ten channels.
Turning the equalizer on/off (EQ ON/OFF)
This parameter allows you to enable (ON) the EQ for each channel or disable (OFF). The box will be highlighted
for the channel with the EQ on.
Range: ON/OFF
When TRACK MIX channels are selected When THRU MIX channels are selected
The maximum number of channels to which you can apply equalization simultaneously varies depending on
the type of EQ (3-band or 2-band) you select for the SETUP parameter (see page 68) and the sampling rate.
NOTE :
When you turn on the EQ for the THRU MIX channel, equalization is always applied to the
input source, even when you are recording signals from the input jacks to tracks. If you do not wish to
apply equalization during recording, set this parameter to OFF. Refer to page 13 (“Signal flow”) for more
information.
While this screen is displayed, the [F5] key and the [F6] key function as follows:
[F5] key .... switches EQ on/off for the selected channel.
[F6] key ........displays all the EQ parameters for the selected channel. See page 64 for more
information.
Setting the frequency rate (EQ HIGH/MID/LOW FREQ)
Channel EQ FREQ parameters allow you to set the base frequency for each range.
Range: HIGH: 500 – 18kHz
MID: 200 – 8kHz
LOW: 40 – 1.5kHz
When TRACK MIX channels are selected When THRU MIX channels are selected
NOTE :
When the 2-band EQ is selected, the EQ MID FREQ parameter does not appear. Use the
SETUP parameter to switch between the 3-band EQ and 2-band EQ. Refer to page 68 for more informa-
tion.
Page view 73
1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 155 156

Comments to this Manuals

No comments