Akai DPS12 Operator's Manual download pdf (Page 68)

Chapter 5: Assigning Input Signals and Virtual Tracks

Assigning a virtual track to a physical track

Pressing the [F4] key in Assign mode causes the following screen to appear. In this screen, you can assign

up to 250 virtual tracks to physical tracks 1–12.

A B C

1 This select field allows you to select one of the 250 virtual tracks. The value indicates a virtual track

number (1–250).

2 This character field indicates the name of the virtual track.

3 This field indicates an assigned physical track (1–12). This field is for display purposes only.

A virtual track that does not contain any recorded data is indicated as . On the other hand, a virtual

track that contains recorded data is indicated as ### (### is replaced by the virtual track number).

(In the example shown above, virtual tracks 1, 2, and 4 already have recording data). You can change the name

of any virtual track.

Follow the procedure below to assign virtual tracks to physical tracks.

1. Use the [CURSOR] key to move the cursor up and down and select a physical track (1–12).

Example: Physical track 2 is selected and has been assigned virtual track 2.

At this time, make sure that the cursor is located at the virtual track number.

2. Turn the [JOG] dial to select a virtual track number (1–250).

Example: Virtual track 5 (not recorded) is assigned to physical track 2.

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 155 156

No comments

Akai DPS12 Operator's Manual Page 68