Akai DPS12 Operator's Manual Page 62

  • Download
  • Add to my manuals
  • Print
  • Page
    / 156
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 61
50
Chapter 4: Punch In/Out
Auto Punch In/Out
Auto Punch In/Out is a function that automatically executes the punch in/out operation if you have specified
punch in/out points. The benefit of this function is that you can concentrate on your performance without being
distracted by the transport operation.
1. Specify the desired punch in/out points as IN and OUT points.
The IN point and OUT point are used to perform the Auto Punch In/Out function. Refer to page 33 for more
information on setting the IN/OUT points.
2. Select AUTO PUNCH for the Control Panel, and set the AUTO PUNCH parameter to “ON”. (Refer to
page 86 for more information on the Control Panel.) The Auto Punch In/Out function now turns on.
3. Locate a position a little before the auto punch in point (a little before the IN point).
4. Use the [RECORD SELECT] key to select a recording track.
The selected track enters record ready mode.
5. Press the [ ] button.
Playback starts with the [REC] button’s LED flashing. You can monitor the recorder’s playback (previously-
recorded sound) through the record-ready track.
When the counter reaches the IN point time, the [REC] button’s LED lights up, and the selected track starts
recording. The monitor signal through the recording track changes to that of the input source (the currently-
recording performance).
TIP :
If the REHEARSAL parameter on the Control Panel has been turned on, the DPS12 enters
“Rehearsal mode,” in which you can practice the punch in operation before you record an actual punch in
take. Refer to page 51 for more information.
When the counter reaches the OUT point time, the [REC] button’s LED turns off and the DPS12 resumes
playback (Auto Punch Out).
6. Press the [ ] button to stop playback.
Playback
Monitoring tracks
Recording
Monitoring inputs
Playback
Monitoring tracks
5
4
3
2
1
RECORD SELECT
Button
operation
IN point OUT point
Physical track
Auto Punch In/Out operation
NOTES :
When the auto punch in/out operation is complete, the AUTO PUNCH parameter of the Control Panel is
set to off. If you wish to perform the auto punch in/out operation repeatedly, it is convenient to have this
Control Panel displayed all the time. (At this time, it is a good idea to specify a position a little before
the IN point as a quick locate point.)
If you press the
[ ]
key between the IN point and the OUT point in Step 5 as mentioned above, record-
ing will start immediately.
Page view 61
1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 155 156

Comments to this Manuals

No comments