Akai DPS12 Operator's Manual download pdf (Page 49)

Chapter 2: Recording on the DPS12

3. Use the [CHANNEL SELECT] keys on the top panel to select the channel for which you wish to set the

parameters.

In Mixer mode, the [CHANNEL SELECT] keys are used to select the desired channel. When the TRACK MIX

channels are selected, use the [CHANNEL SELECT] keys 1–12 to select TRACK MIX channels 1–12. The

cursor moves to a graphic field for the selected channel.

✐

TIP :

You may also move the cursor to a graphic field for any channel, using the

[CURSOR]

key.

4. Select the [F3] key and the [F4] key to select a mix parameter.

The following mix parameters can be selected when the DPS12 is set to default.

• EQ HIGH FREQ (base frequency of high range)

• EQ HIGH LEVEL (level of high range)

• EQ LOW FREQ (base frequency of low range)

• EQ LOW LEVEL (level of low range)

• EQ ON/OFF (equalizer on/off)

• AUX SEND-A (AUX send A level)

• AUX-A PRE/POST (AUX send A pre/post switch)

• AUX SEND-B (AUX send B level)

• AUX-B PRE/POST (AUX send B pre/post switch)

• PAN (panning)

• LEVEL (level)

• CHANNEL (channel on/off)

• SETUP (selecting EQ/AUX type)

• MIDI CONTROL (Setting used to control the mixer section via MIDI)

Example: The EQ HIGH FREQ parameter for TRACK MIX channel 2 is selected.

✐

TIP :

you may also use the

[CURSOR]

key to move the cursor to the field, then rotate the

[JOG]

dial to select a different parameter.

5. Rotate the [JOG] dial to change the parameter value.

The selected channel parameter changes its value.

Example: The EQ HIGH FREQ parameter for TRACK MIX channel 2 is changed to .

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 155 156

No comments

Akai DPS12 Operator's Manual Page 49