Akai DPS12 Operator's Manual download pdf (Page 150)

138

Chapter 13: Using the effects

REVERB>NON-LINEAR (Non-linear Reverb) (G)

This reverb effect (gate reverb) stops reverberation at a specified time.

Parameter Setting range Function

1 Pre-D 1 – 100ms Adjusts the delay time of early reflections.

2 Hold 0 – 127 Adjusts the time (duration) until reverberation is stopped.

3 Diff 0 – 127 Adjusts the density of reverberation.

4 Width 0 – 127 Adjusts the width and spread of the stereo image.

REVERB>REVERSE (Reverse Reverb) (G)

This reverb effect reverses the reverberations.

Parameter Setting range Function

1 Pre-D 1 – 100ms Adjusts the delay time of early reflections.

2 Time 0.1 – 10sec Adjusts the time during which reversed reverberations are played.

3 Diff 0 – 127 Adjusts the density of reverberation.

4 Width 0 – 127 Adjusts the width and spread of the stereo image.

COMPRESSOR/LIMITER (I)

This effect suppresses signals with a certain level or higher and limits the dynamic range. Pressing the /

[F6] key switches the screens of the parameters.

B 5

Parameter Setting range Function

1 Thresh –60dB – 0dB Adjusts the threshold level at which the effect is enabled.

2 Ratio 2:1 – 100:1 Adjusts the compression ratio for signals that exceed the threshold level.

3 Output –24dB – +24dB Adjusts the level of effect sound.

4 Attack 0 – 127 Adjusts the attack time of the effect.

5 Release 0 – 127 Adjusts the release time of the effect.

6 Detect PEAK Changes in the signal level are closely detected.

RMS Averaged level changes are detected.

7 Thresh –60dB – 0dB Adjusts the threshold level at which the noise gate opens.

8 Release 0 – 127 Adjusts the release time of the noise gate.

1 2 ... 145 146 147 148 149 150 151 152 153 154 155 156

No comments

Akai DPS12 Operator's Manual Page 150