Akai DPS12 Operator's Manual download pdf (Page 136)

124

Chapter 13: Using the effects

■ If you selected Insert effects

1. Select TRACK MIX channels in Mixer mode, and adjust the AUX SEND-A or AUX SEND-B level of the

channel to which you wish to apply effects.

At this time, you can check the output level of AUX SENDs A/B using level meters SA/B.

2. Recall the and parameters to select (pre-fader) to send

channel signals to the Insert effects.

3. Recall the parameter, and set the level of the channel signals sent to the Insert effects to 0.

Now signals to which you wish to apply Insert effects are sent from the channel pre-fader position to AUX

SENDs A and B, but they are not output at the master L/R.

Adjusting the effect return level

You can adjust the level, pan, and parameters for the effect return signals sent to the mixer section in the

THRU MIX channels of Mixer mode. Follow the steps below to adjust the level of the effect return signals.

1. Switch to THRU MIX channels in Mixer mode, and recall the parameter.

2. Select the THRU MIX channels to which the effect return signal is routed, and raise the .

If you selected in Assign mode, you can adjust the effect return level of EFFECT A on

THRU MIX channels 3 and 4, and the level of EFFECT B on THRU MIX channels 5 and 6.

If you selected a Global effect, you can adjust only the level of the effect sound on THRU MIX channels. This

effect sound will be mixed with the dry sound of the TRACK MIX channels, and output from the MASTER

OUT jack and OPTICAL OUT jack.

If you selected an Insert effect, you can adjust the level of the mix of the dry and effect sounds. These signals

are mixed with the sound of other tracks on TRACK MIX channels, then output from the MASTER OUT and

OPTICAL OUT jacks.

➸

NOTE :

Make sure that the level of AUX SEND A (when EFFECT A is used) or AUX SEND B (EFFECT

B is used) is set to on the THRU MIX channels to which the effect return signals are input. If the level is

set to any value other than , the signals will loop.

✐

TIP :

Refer to page 58 for more information on operations in Mixer mode.

1 2 ... 131 132 133 134 135 136 137 138 139 140 141 ... 155 156

No comments

Akai DPS12 Operator's Manual Page 136