Akai DPS12 Operator's Manual Page 135

  • Download
  • Add to my manuals
  • Print
  • Page
    / 156
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 134
123
Chapter 13: Using the effects
TIP :
If you selected Global effects for both EFFECT A and B, you may want to select
or . If you have selected Insert effects for either EFFECT A or B or both,
you may want to select .
Routing effect return signals to THRU MIX channels
You can send effect return signals that have been switched as analog input signals to the THRU MIX channels in
the mixer section to mix them with the TRACK MIX channel signals (track playback). Follow the steps below to
send the effect return signals to the mixer section.
1. Press the [F2] key in Assign mode.
2. Select the analog inputs to which the effect return signals are routed, and select as their
destination.
Example: If you selected in Assign mode, route , ,
, , to .
Setting the effect send level
You may set the AUX send level of the TRACK MIX channels to which you wish to apply effects in Mixer mode.
The operation will differ slightly depending on whether you selected Global effects or Insert effects.
If you selected Global effects
1. Select TRACK MIX channels in Mixer mode, and adjust the AUX SEND-A or AUX SEND-B level of the
channel to which you wish to apply effects.
AUX SEND A signal is sent to EFFECT A, and AUX SEND B signal is sent to EFFECT B. At this time, you
can check the output level of AUX SENDs A/B using level meters SA/B. If the level is too high, adjust it using
the channel SEND MASTER and AUX SEND-A/B parameters.
A
You can check the output level of AUX SEND A/B using the meter 1.
2. Recall the and parameters to select whether the signals sent
to EFFECT A/B are routed from the pre-fader or post fader.
Page view 134
1 2 ... 130 131 132 133 134 135 136 137 138 139 140 ... 155 156

Comments to this Manuals

No comments