Akai DPS12 Operator's Manual Page 119

  • Download
  • Add to my manuals
  • Print
  • Page
    / 156
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 118
107
Chapter 11: Using a disk
Defragmenting a disk
Repeated recording and edit operations on the DPS12 fragments audio data written on the disk. If this fragmenta-
tion is significant, recording or playback may be interrupted. The DPS12 enables you to re-align the fragmented
audio data (“defragment”) to solve this problem. Follow the steps below to defragment a disk.
TIP :
You can check the busy meter in the MAIN screen to see how frequently a disk is accessed. If the meter
often appears as shown below, defragment the disk as soon as possible.
Frequent access
NOTE :
When you record and edit on the DPS12 repeatedly, an alarm message may appear, indicating that
there is not enough space on the disk, in actuality the hard disk has enough space available. This means that
the internal audio management table (an area where audio data is managed) on the DPS12 does not have
enough memory space. In this case, you can defragment the disk to reduce the used space in the audio
management table and regain available space on the disk.
1. While the DISK SETUP screen is displayed, move the cursor to the SCSI ID of the drive you wish to
defragment.
2. Press the [F3] key.
The following window appears.
3. Press the [F5] key.
The data alignment operation starts. It takes a few minutes to complete the operation. When it is complete, the
DPS12 returns to the DISK SETUP screen.
NOTE :
The content of the disk determines how long it will take to complete the alignment operation.
When the alignment operation is performed, the UNDO data will be lost.
Copying data in the disk
You may copy all data in the current disk to another disk.
NOTE :
Data existing on the destination disk will be deleted and replaced with the copy source data.
Follow the steps below.
1. While the DISK SETUP screen is displayed, move the cursor to the SCSI ID of the copy source drive.
2. Press the [F5] key in Disk mode.
The DISK COPY window appears.
3. Turn the [JOG] dial and specify the SCSI ID of the copy destination disk.
Page view 118
1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 155 156

Comments to this Manuals

No comments