Akai DPS12 Operator's Manual download pdf (Page 113)

101

Chapter 10: Project management

3. Move the cursor to the select field 1 and select .

4. Move the cursor to the select field 2 and select a Project for backup.

5. Move the cursor to the select field 3 and select a sampling rate for recording on the DAT recorder

( , , ).

If you select in field 1, select field 3 becomes the field, where you can select a

sampling rate for the backup operation.

6. Press the [F6] key.

The following window appears.

7. Start recording on the DAT recorder and press the [F5] key.

Start the backup operation. When the operation is complete, the display returns to the PROJECT screen.

➸

NOTE :

• The time required for the backup operation depends on the sampling rate.

• The backup data does not contain the UNDO data.

CAUTION :

Do not monitor the audio via the DAT during the backup operation. Since audio and other

data is transmitted as a digital signal, an attempt to monitor it may damage the speakers.

✐

TIP :

Press the

[F2]

key to cancel the backup operation.

Reloading the backup Project

Follow the steps below to reload the backup Project from an external DAT or SCSI device.

■ Loading from a SCSI device

1. Press the [F3] key in Project mode.

The DATA RELOAD window appears.

2. Select in the field.

3. Select the in the SCSI ID field for the disk from which you wish to reload the backup data.

4. Press the [F5] key.

➸

NOTE :

If you are reloading data stored on multiple disks, the following window appears. Insert the

next disk.

✐

TIP :

Press the

[F2]

key to cancel the reload operation.

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 155 156

No comments

Akai DPS12 Operator's Manual Page 113