Akai DPS12 Operator's Manual Page 112

  • Download
  • Add to my manuals
  • Print
  • Page
    / 156
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 111
100
Chapter 10: Project management
NOTES:
You cannot directly access backup data on an external SCSI device directly. You must first load the
backup data into the DPS12. See page 99. If you wish to make a copy of the Project that you can access
directly, use the Copy function in Disk mode. (See page 107.)
In Disk mode (see page 103), make sure that the DPS12 recognizes the drive of the SCSI ID you are
going to set.
You can create only one backup Project per disk. You cannot backup multiple Projects on a disk or mix
Project data and backup the data to a disk.
Backing up in multiple disks
If the size of the data to be backed up is larger than the destination removable disk, you may backup into
multiple disks.
Execute the backup operation as usual. When the first disk becomes full, the Change Disk window appears.
Insert a new disk, then select or in the field. Press the [F5]
key to continue the backup operation.
NOTES :
If you press the
[F2]
key at this time, the backup operation will be cancelled and the backup
data on the first disk will not be usable.
Reload data from disks in the order in which you backed up.
Backing up in an external DAT recorder
You can use an external DAT recorder to backup the Project in a DAT tape.
1. Use a standard optical cable to connect the OPTICAL OUT jack on the rear panel of the DPS12 and
the digital input jack on a DAT recorder.
NOTE :
You need to use an optical/coaxial converter if the digital input jacks of the DAT recorder are
coaxial.
DPS12
OPTICAL IN jack
OPTICAL OUT jack
DAT recorder
INPUT
DIGITAL PERSONAL STUDIO
dps12
INPUT GAIN
2. Press the [F2] key in Project mode.
The following window appears.
B
A
C
Page view 111
1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 155 156

Comments to this Manuals

No comments