Akai DR16 pro Operator's Manual download pdf (Page 99)

11: Editing

Page 90

7) Use the CHANNEL ON keys (and the 9-16 key, if necessary) to select the move source

tracks.

8) Use the TRACK REC(INPUT SELECT) keys (and the 9-16 key, if necessary) to select the

move destination tracks.

9) Press the STORE/ENT key to execute the move.

When the DR16pro has completed the move operation, the message will momentarily appear

on the display. The LED beside the EDIT key will switch off and the previous mode will be

restored.

Move+Insert

The move+insert function works basically the same as the move function. However, unlike move,

the move+insert function moves any existing material at the specified destination behind the new

material rather than overwriting it. The following diagram illustrates the move+insert procedure:

Destination insert point

"in" point "out" point

Destination insert point

Source Track

Destination Track

Source and Destination Track

TIME

Source

Source Section

Section

The following steps are similar to “Copy” on page 86, therefore only an outline is provided here.

1) Set the “in” and “out” points to define the move source section.

See “Specifying the “in” Point and “out” Point” on page 26.

2) Locate to the desired position for the destination insert point.

Refer to the “Locate Functions” on page 77.

3) Press the EDIT key to enter Edit Mode.

The EDIT indicator will light up

4) Use the JOG/SHUTTLE control to select the Move+Insert function.

You will see a display similar to the following:

ABS

EDIT

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 166 167

No comments

Akai DR16 pro Operator's Manual Page 99