Akai DR16 pro Operator's Manual Page 87

  • Download
  • Add to my manuals
  • Print
  • Page
    / 167
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 86
9: Locate Functions
Page 78
A quick and convenient method of entering a location value is to use the :/STACK key. This key
pushes two digits of the locate time with one key press. For example, to enter the time 1 hour 5
seconds 6 frames:
Press the LOCATE key.
Press the 1 key, then press the :/STACK key. “01:- -:- -:- -” will appear on the display.
Press the :/STACK key again. “01:0 0:- -:- -” will appear on the display.
Press the 5 key, then press the :/STACK key. “01:0 0:0 5:- -” will appear on the display.
Finally, press the 6 key, then press the :/STACK key. “01:0 0:0 5:0 6” will appear on the display
and the DR16pro will locate to that point.
Direct Locate Points (1 ~ 9 Keys)
Up to nine direct locate points can be stored and recalled using the 1 to 9 numeric keys. These are
called direct locate points because you can locate to the stored point directly, just by pressing the
respective numeric key.
Storing Direct Locate Points
To store a direct locate point:
1) Locate to the desired point.
The location will be shown on the display. See “Locating to the Beginning of a Recording” on
page 77.
2) Press the STORE/ENT key.
The message “MEMORY” will appear on the display and the time display flashes.
3) Press a numeric key to store the direct locate point.
A “LOCATE” message will flash on the display. For example, if you selected the 2 numeric
key, the message “LOCATE 2” will flash on the display. The locate point is stored.
To store a direct locate point during playback or recording:
1) Press the STORE/ENT key when the desired time is reached.
The message “MEMORY” will appear and the time display will freeze at the current location
and start flashing. Playback or recording will continue uninterrupted while you enter the point.
2) Press a numeric key to store the direct locate point.
A “LOCATE” message will flash on the display. For example, if you pressed the 4 numeric key,
the message “LOCATE 4 will flash on the display. The locate point is stored.
Recalling Direct Locate Points
To recall a direct locate point:
1) Press the corresponding 1 to 9 numeric key.
The DR16pro will locate to the stored point.
If no time value has been stored, the DR16pro will locate to the beginning of the disk.
Page view 86
1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 166 167

Comments to this Manuals

No comments