Akai DR16 pro Operator's Manual download pdf (Page 48)

4: Recording

Page 39

Punch-In Functions

Manual Punch-In/Out

Manual punch-in/out allows you to punch-in and punch-out during playback.

1) Set up the DR16pro so that it is ready to record.

Record setup procedures are explained on the preceding pages.

2) Arm the channel that you want to use for punch-in/out.

The TRACK REC key of the armed track will flash.

3) Rewind to a position before the point at which you want to punch-in.

4) Press the Play key to start playback.

5) When the desired punch-in point is reached, press and hold down the Play key, then

press the REC key.

Punch in will occur as soon as the REC key is pressed.

6) Press the Play key again to punch out.

The following diagram shows the procedure for manual punch-in/out:

Manual Punch In/Out Notes

When you punch-in and punch-out, the “in” point and “out” point values are updated automatically.

If you are trying a difficult punch-in/out, perform the manual punch-in/out with the rehearsal func-

tion on (see “Rehearsal” on page 43), then confirm the punch-in/out points using the auto punch-

in/out function. When you are satisfied, switch off the rehearsal function and perform an auto

punch (also see “Auto Punch-In/Out” on page 41).

You can repeat the punch-in and punch-out operations as often as you want. After a punch-out,

you should leave an interval before you punch-in again.

When you punch-out, the monitor switches from source to playback, causing a momentary inter-

ruption in the monitor output. This does not affect the recording at all.

Playback PlaybackRecording Recording

TIME

Punch-in:

Press PLAY and

REC keys

Punch-out:

Press PLAY key

Punch-in:

Press PLAY and

REC keys

Punch-out:

Press PLAY key

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 166 167

No comments

Akai DR16 pro Operator's Manual Page 48