Akai Multi Video Processor RMD-V3104U User Manual download pdf (Page 9)

Signal name

FG.....................................................Frame Ground

TxD

..............................

Transmitted Data

RxD....................................Received Data

RTS

................................

Request to Send

CTS

.....................................

Cleat to Send

DSR

.................................

Data Set Ready

SG.....................................................Signal Ground

Selects the baud rate for the RS-232C.

Baud rate switch (8-bit DIP switch)

Functions of bits

SIfit - Factory preset values

Switch No. Function ON OFF

Parity Yes • Nb":::.--

2 Parity polarity Even

■ ■ ■ ■ ■

vuu

Character bits

Sbfts 7 bits

Stop bits 2 bits

1 bit

Baud rate setting

See table below.

y )Now)

Reserved

g (Note)

Reserved

(Note)

SW7 should always be set to OFF.

SW8 should always be set to ON.

Baud rates available with SWs 5 and 6

SWCi>5 sw(D-6

Baud rate (bps)

ON ON

19,200

OFF ON 9,600

OFF 4JB8&

OFF

2,400

CONTROLS AND CONNECTORS

® MODE switch

Selects the video output mode.

MODE switch details

No. *1

Output Mode Details

Frequency

mode

Output

mode

Standard/

double speed

Middle cut

recovery

mode *3

NTSC

VBS,Y/C Standard OFF

1 RGB

Double speed

8 NTSC VBS,Y/C

Standard

RGB

Double speed

The factory preset is "8".

Standard

............

Horizontal frequency 15.734 kHz

Double speed ... Horizontal frequency 31.468 kHz

(A multi-scan monitor such as the RMD-V4000V or

RMD-V5000Vis required to view video that is produced

by double speed signals.)

When viewing video that contains rapid movement,

there are times when the upper 2 screens do not follow

uniformly with the lower 2 screens. This phenomenon

is called "middle cutting" and can be alleviated by

setting the middle cut recovery mode to ON.

Press this button to reset the system. After the button

is pressed, the system enters the manual mode. In

manual mode, this unit can be controlled using the rear

panel switches, without using a computer.

When the reset button is pressed, this unit functions in

the modes selected by the rear panel switches.

^ COMB cable connector

Connects the interlock cable (cord with 6P mini-DIN

plugs) provided with the display.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 48 49

Comments to this Manuals

No comments

Akai Multi Video Processor RMD-V3104U User Manual Page 9

Comments to this Manuals